Chapter 1 Oracle ZFS Storage Appliance Overview
Chapter 3 Initial Configuration
Chapter 4 Network Configuration
Chapter 5 Storage Configuration
Chapter 6 Storage Area Network Configuration
Chapter 8 Setting ZFSSA Preferences
Chapter 10 Cluster Configuration
Configuring Services Using the BUI
Viewing a Specific Service Screen
Viewing a Specific Service Screen
Configuring Services Using the CLI
iSCSI Service Targets and Initiators
SMB Microsoft Stand-alone DFS Namespace Management Tools Support Matrix
Example: Manipulating DFS Namespaces
Adding a User to an SMB Local Group
SMB Users, Groups, and Connections
Active Directory Configuration
Project and Share Configuration
SMB Data Service Configuration
Allowing FTP Access to a share
HTTP Authentication and Access Control
Allowing HTTP access to a share
Allowing SFTP access to a share
Configuring SFTP Services for Remote Access
Allowing TFTP access to a share
Configuring virus scanning for a share
Adding an appliance administrator from NIS
Adding an appliance administrator
Active Directory Join Workgroup
Active Directory Domains and Workgroups
Active Directory Windows Server 2012 Support
Active Directory Windows Server 2008 Support
Active Directory Windows Server 2008 Support Section A: Kerberos issue (KB951191)
Active Directory Windows Server 2008 Support Section B: NTLMv2 issue (KB957441)
Active Directory Windows Server 2008 Support Section C: Note on NTLMv2
Configuring Active Directory Using the BUI
Configuring Active Directory Using the CLI
Example - Configuring Active Directory Using the CLI
Identity Mapping Rule-based Mapping
Identity Mapping Directory-based Mapping
Mapping Rule Directional Symbols
Identity Mapping Best Practices
Identity Mapping Case Sensitivity
Identity Mapping Domain-Wide Rules
RIP and RIPng Dynamic Routing Protocols
Registering the Appliance Using the BUI
Registering the Appliance Using the CLI
Configuring SNMP to Serve Appliance Status
Configuring SNMP to Send Traps
Receiver Configuration Examples
Configuring a Solaris Receiver
Chapter 12 Shares, Projects, and Schema
The appliance supports backup and restore using both a local configuration, in which tape drives are physically attached to the appliance, and a remote configuration, in which data is streamed to another system on the same network. In both cases, the backup must be managed by a supported DMA.
In local configurations, supported tape devices, including both drives and changers (robots), are physically connected to the system using a supported SCSI or Fibre Channel (FC) card configured in Initiator mode. These devices can be viewed on the NDMP status screen. The NDMP service presents these devices to a DMA when the DMA scans for devices. Once configured in the DMA, these devices are available for backup and restore of the appliance or other systems on the same network. After adding tape drives or changers to the system or removing such devices from the system, a reboot may be required before the changes will be recognized by the NDMP service. After that, the DMA may need to be reconfigured because tape device names may have changed.
In remote configurations, the tape devices are not physically connected to the system being backed up and restored (the data server) but rather to the system running the DMA or a separate system (the tape server). These are commonly called "3-way configurations" because the DMA controls two other systems. In these configurations the data stream is transmitted between the data server and the tape server over an IP network.