Chapter 1 Oracle ZFS Storage Appliance Overview
Chapter 3 Initial Configuration
Chapter 4 Network Configuration
Chapter 5 Storage Configuration
Chapter 6 Storage Area Network Configuration
Chapter 8 Setting ZFSSA Preferences
Chapter 10 Cluster Configuration
Configuring Services Using the BUI
Viewing a Specific Service Screen
Viewing a Specific Service Screen
Configuring Services Using the CLI
iSCSI Service Targets and Initiators
SMB Microsoft Stand-alone DFS Namespace Management Tools Support Matrix
Example: Manipulating DFS Namespaces
Adding a User to an SMB Local Group
SMB Users, Groups, and Connections
Active Directory Configuration
Project and Share Configuration
SMB Data Service Configuration
Allowing FTP Access to a share
HTTP Authentication and Access Control
Allowing HTTP access to a share
NDMP Local vs. Remote Configurations
Allowing SFTP access to a share
Configuring SFTP Services for Remote Access
Allowing TFTP access to a share
Configuring virus scanning for a share
Adding an appliance administrator from NIS
Adding an appliance administrator
Active Directory Join Workgroup
Active Directory Domains and Workgroups
Active Directory Windows Server 2012 Support
Active Directory Windows Server 2008 Support
Active Directory Windows Server 2008 Support Section A: Kerberos issue (KB951191)
Active Directory Windows Server 2008 Support Section B: NTLMv2 issue (KB957441)
Active Directory Windows Server 2008 Support Section C: Note on NTLMv2
Configuring Active Directory Using the BUI
Configuring Active Directory Using the CLI
Example - Configuring Active Directory Using the CLI
Identity Mapping Rule-based Mapping
Identity Mapping Directory-based Mapping
Mapping Rule Directional Symbols
Identity Mapping Best Practices
Identity Mapping Case Sensitivity
Identity Mapping Domain-Wide Rules
RIP and RIPng Dynamic Routing Protocols
Registering the Appliance Using the BUI
Registering the Appliance Using the CLI
Configuring SNMP to Serve Appliance Status
Configuring SNMP to Send Traps
Receiver Configuration Examples
Configuring a Solaris Receiver
Chapter 12 Shares, Projects, and Schema
Version: Toggles between v1/2c and v3.
Community name: Toggles between public and user-input. If you select user-input, you must also enter a community name. If you select v3, this property is not available.
Authorized network/subnet: Enter an appropriate IPv4 address and subnet (integers from 0-32). If you select v3, this property is not available.
Appliance contact: Enter an appropriate appliance contact.
Username/password: Enter a valid username (max 501 characters) and password (8-501 characters). If you select v1/2c, this property is not available.
Authentication: Toggles between MD5 and SHA authentication algorithms. If you select v1/2c, this property is not available.
Privacy: Toggles between None and DES encryption algorithm. If you select v1/2c, this property is not available.
Engine ID: The EngineID value hashed by snmpd. If SNMP was not previously enabled, the label shows “0x000”.
Trap destinations: Lets you add IPv4 addresses. Use the “+” and “-” buttons to add or remove addresses.
Changing services properties is documented in Configuring Services Using the BUI and Configuring Services Using the CLI. The CLI property names are shorter versions of those listed above.
The SNMP service also provides the MIB-II location string. This property is sourced from the System Identity configuration.