Install the Server Into the Slide-Rail Assemblies
Use this procedure to install the server chassis, with mounting brackets, into the slide-rail
assemblies that are mounted to the rack.
| Caution -
This procedure requires a minimum of two people because of the weight of the server.
Attempting this procedure alone could result in equipment damage or personal injury.
|
| Caution -
Always load equipment into a rack from the bottom up so that the rack will not become
top-heavy and tip over. Extend your rack's anti-tilt bar to prevent the rack from tipping during
equipment installation.
|
-
Push the slide-rails as far as possible into the slide-rail assemblies in the rack.
-
Position the server so that the rear ends of the mounting brackets are aligned with the
slide-rail assemblies that are mounted in the rack.
-
Insert the mounting brackets into the slide-rails, and then push the server into the rack
until the mounting brackets encounter the slide-rail stops (approximately 30 cm, or 12 inches).
|
|
1
|
Inserting mounting bracket into slide-rail
|
2
|
Slide-rail release button
|
3
|
Slide-rail lock
|
|
-
Simultaneously push and hold the green slide-rail release buttons on each mounting bracket
while you push the server into the rack. Continue pushing the server into the rack until the
slide-rail locks (on the front of the mounting brackets) engage the slide-rail assemblies.
You will hear an audible click.
| Caution -
Verify that the server is securely mounted in the rack and that the slide-rail locks are
engaged with the mounting brackets before you install the optional cable management arm.
|