Install an NVMe Storage Drive in the Server
Perform this procedure to physically install an NVMe
storage drive into the server.
Note -
After you physically remove an NVMe storage drive
from the server, wait at least 10 seconds before
installing a replacement drive.
-
Remove the replacement drive from its packaging
and place the drive on an antistatic mat.
-
If necessary, remove the drive filler
panel.
-
Align the replacement drive with the drive
slot.
The drive is physically addressed according to the
slot in which it is installed. It is important to
install a replacement drive in the same slot as the
drive that was removed.
-
Slide the drive into the slot until the drive is
fully seated.
See
Step 1.
-
Close the drive latch to lock the drive in
place.