Remove the Main Module
-
(Optional) If you are replacing a faulty main module, you must back up ILOM
configuration settings.
-
Configure the SER MGT port to enable the configuration parameters to
be uploaded.
Refer to the ILOM documentation for network configuration instructions.
-
Back up the ILOM configuration parameters.
Refer to the ILOM documentation (http://www.oracle.com/goto/ilom/docs).
-
Configure the SER MGT port to enable the configuration parameters to
be uploaded.
- Ensure that the server is powered off. Power off the server.
- Disconnect the power cords.
- Locate the main module in the server.
-
Squeeze the release latches together on the two extraction levers, and pull
the extraction levers out to disengage the main module from the server.
-
Pull the main module halfway out of the server.
-
Press the levers back toward the center of the main module.
This will keep the levers from being damaged when the main module is outside the server.
Caution - Due to the weight of the main module, the following step requires two people to perform. Do not attempt to lift the main module alone.
- Remove the main module completely from the server.
-
Consider your next steps:
- If you have removed the main module to prepare the server for installation, return to Preparing for Installation in SPARC T7-4 Server Installation Guide.
-
If you have removed the main module to service an internal component,
remove the cover from the main module.
Press the green button near the front edge of the cover and slide the cover back and up off the main module.
-
Determine your next step.
- If you are replacing a main module due to a faulty motherboard, remove all of the internal components, and transfer them to the new main module.
- If you are replacing a component inside the main module, use one of the following links: