-
Follow safety and ESD precautions.
See Safety and ESD Precautions.
-
Using a No. 3 Phillips screwdriver, remove the fours screws (two on each
side) holding the LED panel to the front of the modular system.
Note -
It might be easier to perform this step if you remove the filler panel
at slot 40.
-
Gently pull the LED panel out so as to not damage the DB-9 LED cable.
-
Loosen the thumbscrews and carefully disconnect the DB-9 LED cable.
If you are replacing the cable, see Replace the DB-9 LED Cable.
-
Remove the cable protector from the rear top edge, and save it for reuse on the replacement LED panel.
-
Discard the faulty LED panel.
-
Install the new LED panel.
See Install the LED Panel.