Go to main content

Oracle^® Server X7-2L Service Manual

Exit Print View

» ...Documentation Home » Oracle^® Server X7-2L Service ... » Identifying the Server Ports » USB Ports

Updated: January 2021

Oracle^® Server X7-2L Service Manual

Document Information

Using This Documentation

About the Oracle Server X7-2L

Troubleshooting and Diagnostics

Preparing for Service

Servicing Storage Drives (CRU)

Servicing Fan Modules (CRU)

Servicing Power Supplies (CRU)

Servicing the Internal M.2 Flash SSDs (CRU)

Servicing an Internal USB Flash Drive (CRU)

Servicing the Air Baffle (CRU)

Servicing the DIMMs (CRU)

Servicing PCIe Cards (CRU)

Servicing the Battery (CRU)

Servicing Processors (FRU)

Servicing the Disk Backplane (FRU)

Servicing the Front LED Indicator Module (FRU)

Servicing the Temperature Sensor (FRU)

Servicing the Internal HBA Card (FRU) and HBA Super Capacitor (CRU)

Servicing SAS Cables (FRU)

Servicing NVMe Cables (FRU)

Servicing the Motherboard Assembly (FRU)

Returning the Server to Operation

Identifying the Server Ports

Gigabit Ethernet Port

Network Management Port

Serial Management Port

Setting Up BIOS Configuration Parameters

BIOS Setup Utility Menu Options

Monitoring Components and Identifying SNMP Messages

Language:

USB Ports

The server has two USB ports for attaching supported USB 3.0–compliant devices. One USB port is on the back panel and one USB port is located on the motherboard.

The following figure and table describe the USB port pin signals.

image:Figure showing a USB port.

Table 9 USB Port Signals

Pin	Signal Description
1	+5 V
2	USB 2.0 DAT-
3	USB 2.0 DAT+
4	Ground
5	USB 3.0 RX-
6	USB 3.0 RX+
7	Ground
8	USB 3.0 TX-
9	USB 3.0 TX+

Related Information

Copyright © 2017, 2021, Oracle and/or its affiliates.