Oracle^® Server X7-2L Service Manual

Remove a Flash Riser Board

The server can contain up to two hot-pluggable flash riser boards. Each flash riser board can contain either one or two M.2 flash SSDs.

1. Prepare the server for service.
   1. Extend the server into maintenance position.

      See Extend the Server to the Maintenance Position.

   2. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.

      See Take Antistatic Measures.

   3. Remove the server top cover.

      See Remove the Server Top Cover.

2. To remove the flash riser board, do the following:
   1. Rotate both riser board socket levers outward as far as they will go.

      ---

      Note -  The green Power LED indicator located on the riser board is extinguished when you open the socket levers.

      ---

   2. Carefully lift the riser board straight up to remove it from the sockets.

      Place the riser board on an antistatic mat. If required, perform the procedure for removing an M.2 flash SSD from the flash riser board. See Identify and Remove an M.2 Flash SSD.

      
      

Related Information

• Install a Flash Riser Board

• Identify and Remove an M.2 Flash SSD