|Skip Navigation Links|
|Exit Print View|
|man pages section 7: Device and Network Interfaces Oracle Solaris 10 8/11 Information Library|
- SCSI HBA driver for LSI MegaRAID SAS controller
The mega_sas MegaRAID controller host bus adapter driver is a SCSA-compliant nexus driver that supports the Dell PERC 5/E, 5/i, 6/E and 6/i RAID controllers, the IBM ServeRAID-MR10k SAS/SATA controller and the LSI MegaRAID SAS/SATA 8204, 8208, 8308, 84016, 8704, 8708, 8300, 8708, 8408, 8480, 8344, 8880 and 8888 series of controllers.
Supported RAID features include RAID levels 0, 1, 5, and 6, RAID spans 10, 50 and 60, online capacity expansion (OCE), online RAID level migration (RLM), auto resume after loss of system power during arrays, array rebuild or reconstruction (RLM) and configurable stripe size up to 1MB. Additional supported RAID features include check consistency for background data integrity, patrol read for media scanning and repairing, 64 logical drive support, up to 64TB LUN support, automatic rebuild and global and dedicated hot spare support.
The mega_sas.conf file contains no user configurable parameters. Please configure your hardware through the related BIOS utility or the MegaCli configuration utility. If you want to install to a drive attached to a mega_sas HBA, you should create the virtual drive first from the BIOS before running the Solaris install. You can obtain the MegaCli utility from the LSI website.
The mega_sas device can support up to 64 virtual disks. Note that BIOS numbers the virtual disks as 1 through 64, however in the Solaris operating environment virtual disks are numbered from 0 to 63. Also note that SAS and SATA drives cannot be configured into the same virtual disk.
32-bit ELF kernel module. (x86)
64-bit kernel module. (x86)
Driver configuration file (contains no user-configurable options).
See attributes(5) for descriptions of the following attributes:
Small Computer System Interface-2 (SCSI-2)