Install the CMA Comb
You will be installing the single-unit CMA comb.
For installation of the multi-piece CMA, see Install the CMA (Multi-piece CMA).
The CMA is attached to the rear posts of the rack.
Note - The CMA installation might block some of the power outlets
in the rack, making them unavailable.
- Confirm
that you have the correct hardware to install the CMA (Determine Correct Rackmount Hardware).
- At the front of the system, remove four screws, two per
side.
- At the rear of the system, on
square hole racks, remove the middle adapter screw on each side
and push the system forward 3 in. (76 mm).
| Caution - Do not remove the top adapter screw
on the square hole racks. |
- Attach the left and right CMA
brackets to the comb, using three M6 screws per side.
- Attach the CMA comb to the rack
posts, using two M6 screws per side.
- At the front of the system, push
the system back until it touches the rails.
- Reinstall the four screws, two per
side.