Documentation, Support, and Training
Understanding ILOM on the Switch
Administering ILOM (Web Interface)
Understanding Switch-Specific Commands
activate Command (switch-specific)
deactivate Command (switch-specific)
Sets a switch chip port speed. Issued on the CMC.
setlinkspeed lc|fc slot switch_chip port speed
where:
slot is number of the line card (0–8) or fabric card (0–8).
switch_chip is the number of the chip on the line card (0–3) or fabric card (0–1).
port is the number of the port (1–36).
speed is the bandwidth of the port qdr, ddr, or sdr.
This switch-specific command sets the speed of a port on a particular switch chip in a line card or fabric card. The speed set is singular and not a limit. If too many symbol errors are encountered, try setting for a slower speed (ddr or sdr).
The following example shows how to set the speed of port 3 on switch 0 of line card 8 to quad data rate (qdr) with the setlinkspeed command.
# setlinkspeed lc 8 0 3 qdr #