If the Oracle ILOM SP is unresponsive and you cannot reset it using the Oracle ILOM web interface or the Oracle ILOM CLI command, use the following procedure to reset the SP from the server back panel.
The stylus should be non-conductive with a diameter no more than 1.5 mm. To depress the pinhole button, the stylus should reach 6.5 mm into the chassis. Care should be taken to not over penetrate into the chassis, or probe the sensitive electrical components near the button.
Caution - Using a conductive tool, such as a metal paper clip or graphite pencil, can cause a short that can cause an immediate host power off, and/or circuit damage.
The Reset SP pinhole is located on the server back panel beneath the USB ports. For more information, refer to Rear Panel Pinhole Switches in Oracle Server X6-2L Service Manual.
The SP reboots. You must log in again to continue working in Oracle ILOM.