Connect Cables and Power Cords
Refer to Rear Panel Cabling Reference to locate the
ports and AC inlets on the server back panel.
-
Connect a serial cable between the server's serial management port (SER MGT)
and a terminal device.
This connection provides the initial communication to the SP.
-
(Optional) Connect an Ethernet cable between the network management port (NET
MGT) and the network to which connections to the Oracle ILOM SP and host will be
made.
Configure the server for the first time using the SER MGT port. After initial
configuration, you can set up communication between the SP and host through this
Ethernet interface.
-
For network access, connect an Ethernet cable between one of the the server's
Ethernet NET ports (NET0-3) and the network to which the server will
communicate.
Note -
Ethernet ports NET2 and NET3 are non-functional in single-processor
systems.
-
Connect the power cords to the two AC inlets on the back panel of the
server.
Use a Velcro strap to secure the power cords to the power supply handle as
shown in the following figure.
| Caution -
Damage to Server Components: Do not
operate the server unless all fans, component heak sinks, air baffles, and the
top cover are installed.
|