Use the Auto Mode Sequencer (GUI)

Use the Mode Sequencer to determine the sequence of tests that will be run in Auto mode. By default, the Sequencer is switched off (set to Disable).

1. In the main page of the GUI, click Mode Sequencer.

   The Auto Mode Sequence screen is displayed.

2. In the Sequencer field, select Enable.
3. Select the modes.

   • First: Select one of the three test modes that will run first. By default, this option is set to None.

   • Second: Select one of the three test modes that will run second. By default, this option is set to None.

   • Third: Select one of the three test modes that will run third. By default, this option is set to None.

4. In the Loop field, specify the number of times the sequence will run.

   The value must be between 1 and 99999. By default, this is set to 1.

5. Click Ok to apply the changes.

Related Information

• Auto Mode Sequencer

• GUI Overview

• Configuring the Test Session (GUI)

• Begin the Test Session (GUI)

• Monitor the Test Session

• Stop the Test Session (GUI)

• Review the Log Files (GUI)

• Delete the Log Files (GUI)

• Reset the Test Session (GUI)

• Saving a Test Session Configuration for Repeated Use (GUI)

• Quit the GUI