Verifying Operation of ZS3-2 Slide-Rails and CMA
Use the following procedure to verify the operation of the optional CMA and slide
rails on a ZS3-2 controller.
Before You Begin
Ensure all rack anti-tilt devices are extended to prevent the rack from tipping
forward when the storage controller is extended from the rack.
-
Slowly pull the storage controller out of the rack until the slide-rails reach
their stops.
-
Inspect the attached cables for any binding or kinks.
-
Verify that the CMA extends fully with the slide-rails.
-
Push the storage controller back into the rack and verify that the CMA
retracts without binding.
-
Adjust the cable straps and the CMA, as required.