Installing the Slide Rails onto a ZS5-4
Use the following procedure to install the slide rails onto a ZS5-4
controller.
Note -
The slide rails can be used with either 9.5-mm square or M6 round mounting
hole racks.
-
Position a mounting bracket against the chassis so that the slide-rail lock is
at the front of the chassis, and the five keyhole openings on the mounting
bracket are aligned with the five locating pins on the side of the chassis.
Note -
The mounting brackets are identical and can be installed on either side of
the chassis.
-
With the heads of the five chassis locating pins protruding through the five
keyhole openings in the mounting bracket, pull the mounting bracket toward the
front of the chassis until the mounting bracket clip locks into place with an
audible click.
-
Verify that the rear locating pin has engaged the mounting bracket
clip.
-
To install the other mounting bracket on the other side of the chassis, repeat
Steps 1 through 3.