This section provides an overview of the Oracle ZFS Storage ZS3-4 controller. For installation instructions, refer to Installing a ZS4-4 or ZS3-4 Controller. For service instructions, refer to Servicing the ZS3-4 Controller in Oracle ZFS Storage Appliance Customer Service Manual.
The following list shows the electrical specifications for the ZS3-4 controller.
Input
Nominal frequencies: 50/60Hz
AC operating range: 200-240 VAC
Maximum current AC RMS: 12A @ 200 VAC
Power Dissipation
Max power consumption: 1800 W
Max heat output: 6143 BTU/hr
Volt-Ampere rating: 1837 VA @ 240 VAC, 0.98 P.F.
The ZS3-4 controller can be configured as a single controller or two controllers to create a high-availability cluster configuration. The following table describes the configuration options:
|
Refer to http://oracle.com/zfsstorage for the most recent component specification.
Figure 32 ZS3-4 Front Panel
|
The ZS3-4 controller has two SAS-2 system boot drives in slots 0 and 1, configured as a mirrored pair. Up to four SAS-2 read cache SSDs can fill slots 2 through 5, in order. For information about supported HDDs and SSDs, see the Oracle Systems Handbook.
Figure 33 System Boot Drive LEDs
|
The following graphic shows the rear panel of the ZS3-4 controller. Base configuration HBAs are not depicted in this illustration.
For information about PCIe cards, see ZS3-4 PCIe I/O Cards in Oracle ZFS Storage Appliance Customer Service Manual.
Figure 34 ZS3-4 Rear Panel Components
|
Ethernet Ports - The ZS3-4 has four RJ-45 Gigabit Ethernet connectors (NET 0, NET 1, NET 2, NET 3) located on the motherboard that operate at 10/100/1000 Mbit/sec. These network interfaces must be configured before use.
Network Management Port - The network management connector (NET MGT) is an RJ-45 10/100 BASE-T Ethernet port and provides a LAN interface to the SP console.
Serial Management Port - The serial management connector (SER MGT) is an RJ-45 connector and provides a terminal connection to the SP console.
HBA Ports - The 4x4 SAS-2 HBA, installed in the ZS3-4, provides connectivity to external DE2 and Sun Disk Shelves. The HBA logical ports are numbered 3-0, top to bottom: