|
Storage drive (EF only)
|
-
Locate the storage drive filler panel you want to
remove from the server.
-
To unlatch the storage drive filler panel, pull
the release lever, and tilt the lever out into a
fully opened position.
-
To remove the filler panel from the slot, hold the
opened release lever, and gently slide the filler
panel toward you.
|
-
Locate the vacant storage drive module slot in the
server, and ensure that the release lever on the
filler panel is fully opened.
-
Slide the filler panel into the vacant slot by
pressing the middle of the filler panel faceplate
with your thumb or finger.
The release lever goes in as it makes contact with
the chassis. Do not slide the filler panel in all
the way. Leave the filler panel out approximately
0.25 to 0.50 inch (6 to 12 mm) from the
opening.
-
Using your thumb or finger, press on the middle of
the filler panel faceplate until the release lever
engages with the chassis.
-
Close the release lever until it clicks into place
and is flush with the front of the server.
|
|
PCIe slot
|
-
Remove the server top cover.
-
To remove the PCIe slot filler panel, rotate the
PCIe locking mechanism to an upright position, and
lift and remove the PCIe slot filler panel from the
location into which you intend to install the PCIe
card.
|
-
Remove the server top cover.
-
To install the PCIe slot filler panel, press the
PCIe filler panel into the vacant PCIe slot, and
rotate the PCIe locking mechanism downward to secure
the PCIe slot filler panel. You hear an audible
click when the PCIe filler panel is secured into the
slot.
|