| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Queries InfiniBand addresses. Issued on the Linux InfiniBand host.
ibaddr [-d][-D][-G][-l][-g][-C ca_name][-P ca_port][-t timeout][-V][-h] [lid|dr_path|guid]
where:
ca_name is the channel adapter name.
ca_port is the channel adapter port.
timeout is the timeout in milliseconds.
lid is the local identifier.
dr_path is the directed path.
guid is the global unit identifier.
This InfiniBand software command displays the LID and range as well as the GID address of the port specified. The local port information is provided by default.
Note - This command is also used as a simple address resolver.
The following table describes the options to the ibaddr command and their purposes:
|
The following example shows how to display the local port’s GID and LID range with the ibaddr command.
# ibaddr GID fe80::3:ba00:100:c70a LID start 0x3a end 0x3a #
ibaddr man page
|