showpresent Command

Displays components present. Issued on the CMC.

Syntax

showpresent

Description

This switch-specific command displays physically installed power supplies, line cards, and fabric cards. If a line card or fabric card is present, its activity is also displayed.

Example

The following example shows how to display components sensed in the chassis with the showpresent command.

# showpresent
PSU 00 present, state = ON
PSU 01 present, state = ON
PSU 02 present, state = ON
PSU 03 present, state = ON
FC 00 present and active (state = M4)
FC 01 present but not active (state = M1)
FC(F) 02 present but not active (state = unknown)
FC 03 present and active (state = M4)
FC 04 present and active (state = M4)
.
.
.
#

In this example, fabric card 1 has been deactivated. Because fabric card slot 2 has had standby voltage disabled, it is not possible for the CMC to determine if the component installed is a fabric card or a fabric card filler.

The string (state = M4) means the FRU is in an active state. Other states are identified by the following:

• M0 – Not installed

• M1 – Inactive

• M2 – Activation request

• M3 – Activation in progress

• M4 – FRU active

• M5 – Deactivation request

• M6 – Deactivation in progress

• M7 – Communication lost

Related Information

• checkfans Command

• m9diag Command

• psustatus Command

• ipmc Command

• showunhealthy Command