| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Sets LAN configuration parameters. Issued on the CMC.
getlanconfig channel [parameter [additional_parameters]]
where:
channel is the numeric identifier of the channel.
parameter is either the parameter name or the respective number of the parameter.
additional_parameters are additional parameters.
This CLIA command sets the value of the specified LAN configuration parameter on the specified channel. Refer to LAN Configuration Parameters for information about the configuration parameters.
The following example shows how to set the destination address of channel 1 with a set selector 2 and the default gateway with the setlanconfig command.
# clia setlanconfig 1 destination_address 2 0 172.16.2.100 90:93:93:93:93:93 Pigeon Point Shelf Manager Command Line Interpreter Destination Addresses set successfully #
|