| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Enables hot insertion of a card. Issued on the CMC.
enablehotinsert lc|fc slot
where slot is the number of the line card (0–8) or fabric card (0–8).
This switch-specific command readies the IPMB bus and standby power for a line card or fabric card slot before insertion, so that the bus and power are automatically enabled upon line card or fabric card insertion into that slot. This command is similar to the enableboard command or the enableipmb and enablestby commands, but is executed before the card is inserted.
The following example shows how to ready line card slot 8 for hot-insertion with the enablehotinsert command.
# enablehotinsert lc 8 lc 8 is now enabled #
|