| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Sets the locked bit. Issued on the CMC.
setlocked IPMB_address FRU_ID 0 | 1
where:
IPMB_address is the IPMB bus address of the component.
FRU_ID is the FRU identifier of the component or portion of the component.
This CLIA command sets the locked bit for the specified FRU to the specified state (0 for unlock or 1 for lock).
The locked bit controls whether the FRU is allowed to autonomously progress from state M1 (inactive) to state M2 (activation request). If the locked bit is set, this transition is not allowed.
This command can be used to reactivate a previously manually deactivated FRU by clearing the locked bit for it.
The following example shows how to clear the locked bit for the IPM controller at IPMB address 92 (line card 8), thus allowing it to reactivate using the setlocked command.
# clia setlocked 92 0 0 Pigeon Point Shelf Manager Command Line Interpreter Lock set successfully to 0x0 #
|