| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Sets component to debug. Issued on the CMC.
selectdebugport lc|fc slot
where slot is number of the line card (0–8) or fabric card (0–8).
This switch-specific command enables you to directly communicate with the H8 chip of the specified line card or fabric card, circumventing the indirect control of the CMC software. The selectdebugport command sets which line card or fabric card is addressed through the debug port of the CMC. The debug port is located between the NET MGT and SER MGT connectors, and uses the serial communication parameters of 9600, 8, N, 1, and no flow control.
Note - Resetting a CMC or performing a CMC switchover resets the debug port.
The following example shows how to set line card 8 for debugging through the debug port on the CMC with the setdebugport command.
# selectdebugport lc 8 #
|