| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Resets a switch chip. Issued on the CMC.
resetswitch lc|fc slot switch_chip state
where:
slot is number of the line card (0–8) or fabric card (0–8).
switch_chip is the number of the chip on the line card (0–4) or fabric card (0–1). Using a value of 255 affects all switch chips on the card.
state is 0 to reset once, and 1 to hold in reset.
This switch-specific command resets a switch chip on a line card or fabric card. Reset can be one time, or reset can be held indefinitely until the switch is reset again.
The following example shows how to reset switch chip 0 on line card 8 with the resetswitch command.
# resetswitch lc 8 0 0 #
|