Documentation, Support, and Training
Sun Storage F5100 Flash Array Overview
Obtaining the Chassis Serial Number
Choosing a Method for Diagnosing Faults
Diagnosing Faults With Sun StorageTek Common Array Manager Software
Diagnosing Faults With LEDs and Indicators
Preparing to Service the System
Performing an Antistatic Discharge
Customer-Replaceable and Field-Replaceable Components
Verify Flash Module Replacement
Verify Power Supply Replacement
Replacing an Energy Storage Module
Remove an Energy Storage Module
Install an Energy Storage Module
Verify Energy Storage Module Replacement
Replacing the Motherboard Assembly
Remove the Motherboard Assembly
Install the Motherboard Assembly
Verify Motherboard Replacement
Remove a Power Distribution Board
Install a Power Distribution Board
Verify Power Distribution Board Replacement
Replacing the Connector Board Assembly
Remove the Connector Board Assembly
Install a Connector Board Assembly
Verify Connector Board Replacement
Replacing the Energy Storage Backplane
Remove the Energy Storage Backplane
Install the Energy Storage Backplane
Verify Energy Storage Backplane Replacement
Returning the System to Service
Install the Chassis to Maintenance Position
Return the System to the Fully Installed Position
The system management software on the host will alert you when the power distribution board (PDB) fails and needs to be replaced.
It is easier to service the power distribution board (PDB) with the bus bar assembly attached. If you are replacing a faulty PDB, you must remove the bus bar assembly from the old PDB and attach the assembly to the new PDB. In addition, you must reprogram the new PDB with the chassis serial number. Contact Sun Service to reprogram a new PDB.You must remove the PDB to access the connector board.
Caution - The system supplies power to the PDB even when the array is powered off. To avoid personal injury or damage to the array, disconnect power cords before servicing the PDB. |