Documentation, Support, and Training
Sun Storage F5100 Flash Array Overview
Obtaining the Chassis Serial Number
Choosing a Method for Diagnosing Faults
Diagnosing Faults With Sun StorageTek Common Array Manager Software
Diagnosing Faults With LEDs and Indicators
Preparing to Service the System
Performing an Antistatic Discharge
Customer-Replaceable and Field-Replaceable Components
Verify Flash Module Replacement
Verify Power Supply Replacement
Replacing an Energy Storage Module
Remove an Energy Storage Module
Install an Energy Storage Module
Verify Energy Storage Module Replacement
Replacing the Motherboard Assembly
Remove the Motherboard Assembly
Install the Motherboard Assembly
Verify Motherboard Replacement
Replacing a Power Distribution Board
Remove a Power Distribution Board
Install a Power Distribution Board
Verify Power Distribution Board Replacement
Replacing the Connector Board Assembly
Remove the Connector Board Assembly
Install a Connector Board Assembly
Verify Connector Board Replacement
Replacing the Energy Storage Backplane
Install the Energy Storage Backplane
Verify Energy Storage Backplane Replacement
Returning the System to Service
Install the Chassis to Maintenance Position
Return the System to the Fully Installed Position
Note - The system must be completely powered down before this component is replaced. This component must be replaced only by qualified service technicians. Contact your Sun Service representative for assistance.
Caution - Performing a complete power down of the system ensures that any residual power in the ESMs is discharged by the time you remove the ESM. Never attempt to remove an ESM unless the blue Ready-to-Remove LED on the front of the ESM is illuminated or the power has been completely removed from the system. |
Refer to Completely Power Off the System.
Refer to Perform Static Discharge Procedures.
Refer to Remove the Chassis From the Rack.
Depending on the type of rail kit you have installed, removing these glides will involve one of the following procedures:
Refer to Access Internal Components.
Figure 42 Removing Cables From the Backplane
Place the assembly upright with the front of the assembly on a firm surface and an antistatic mat beneath it.
Figure 43 Removing the Energy Storage Backplane