Documentation, Support, and Training
Evaluating Product Compatibility
Form-Factor Physical Characteristics
Warranty and Technical Support
System Requirements and Options
Installing Optional Components
Preparing to Install the Blade Server
Power and Thermal Distribution
Required Cooling and Blade Impedance Curve
Local Network IP Addresses and Host Names
Connect the External I/O Cables
Connect Cables to a System Console Running the Oracle Solaris OS
Connect Cables to a System Console Not Running Oracle Solaris OS
Insert and Latch the Blade Server
Software and Firmware Upgrades
Software and Firmware Upgrades
Firmware and Blade Server Management
Creating a Boot Disk Server and Adding Clients
Create a Boot Server for Diskless Clients
Compact Flash Formatting for the Oracle Solaris OS
Multiplex Configuration of Zones 2 and 3
Advanced Rear Transition Module Connectors (Zone 3)
Locate Base MAC Address on Blade Server
Configuring and Using Serial Over LAN
Set Up Default Gateway IP Address
Users Supported in SOL Implementation
Create or Modify SOL User Name and Password
Shut Down OS and Deactivate the Blade Server
Power Off and Remove the Blade Server
The OEM command Set SOL Fail over Link change timeouts enables you to set the time-out period for when IPMC switches over to the secondary link because the primary fails. This setting also specifies how long to wait before switching back to the primary when it becomes available.
Note - Default settings are recommended over user-customized settings.
For information about how to set SOL failover link change timeouts, refer to the Sun Netra CT900 Server Administration and Reference Manual.
For detailed information about SOL, refer to Intelligent Platform Management Interface Specification v2.0.