Configure RAID in Legacy Boot Mode

1. Power on or reset the server (host).

   For example, do one of the following:

   • From the local server, press the Power button (approximately 1 second) on the front panel of the server to power off the host, then press the Power button again to power it back on.

   • From the Oracle ILOM web interface, select Host Management > Power Control, then select Reset from the Select Action list box.

   • From the Oracle ILOM CLI, type: reset /System

   The BIOS screen appears.

   During the boot process, the BIOS initialization banner lists information about the discovered SAS adapters and devices that are attached to the discovered HBAs in the system.

2. Press Ctrl+C when you see the following prompt:

   Press Ctrl-C to start LSI Corp Configuration Utility...

   The LSI Corp Config Utility menu appears.

   
   
3. Use the LSI Corp Config Utility to configure RAID on the server.

   For instructions on how to use the BIOS configuration utilities to configure RAID in legacy boot mode, refer to instructions for creating a bootable drive on x86/64 systems in the Sun Storage 6 Gb SAS PCIe HBA, Internal Installation Guide For HBA Models SGX-SAS6-INT-Z and SG-SAS6-INT-Z at: http://docs.oracle.com/cd/E19337-01/index.html.

See Also

• Set Up an Operating System and Drivers