-
Attach an antistatic wrist strap to your wrist, and then to a metal area
on the chassis.
See Take Antistatic Measures.
-
Carefully lift and place the motherboard assembly into the chassis
[1].
Tilt the motherboard to the right side to fit under the power supply
assembly, level the motherboard and place it into the server chassis, then
slide it to the rear of the server to engage the raised standoffs.
-
Install the mid-wall into the chassis.
-
Lift and place the mid-wall into the chassis [2].
-
Using a No. 2 Phillips screwdriver, tighten the four green captive
screws that secure the mid-wall to the bottom of the chassis
[3].
-
Using a hex/flat head screwdriver, insert and tighten the screw on
each side of the chassis to secure the mid-wall in the chassis
[4].
-
Reconnect the power cable to the motherboard from the rear storage drive
backplane [5].
See Servicing the Front and Rear Storage Drive Backplanes (FRU).
-
Reconnect the auxiliary signal cable to the motherboard from the front
storage drive backplane [5].
See Servicing the Front and Rear Storage Drive Backplanes (FRU).
-
Reconnect the ribbon cables from left and right LED/USB indicator modules
to the motherboard [6].
See Servicing the Front LED/USB Indicator Modules (FRU).
-
Reconnect the power cable to the motherboard from the front storage drive
backplane [6].
See Servicing the Front and Rear Storage Drive Backplanes (FRU).
-
Reconnect the server intrusion switch cable to the motherboard [6].
-
If the server has a DVD drive, reconnect the DVD drive cable.
To reconnect the DVD drive cable, carefully guide it through the chassis
mid-wall and reconnect it to the motherboard SATA connector.
See Install the DVD Drive.
-
Reinstall the following components:
![Caution Caution](graphics/caution.gif) | Caution -
When reinstalling power supplies, it is important to reinstall them
into the slots from which they were removed during the motherboard
removal procedure; otherwise, the server key identity properties (KIP)
data might be lost. When a server requires service, the KIP is used by
Oracle to verify that the warranty on the server has not expired. For
more information on KIP, see FRU Key Identity Properties (KIP) Automated Update.
|
-
Install the air baffle.
Install the air baffle by placing it into the server. Leave the air baffle
in an upright position in preparation for installing the Oracle Storage 12
Gb/s SAS PCIe RAID HBA card.
-
Install the Oracle Storage 12 Gb/s SAS PCIe RAID HBA card and its
associated super capacitor.
See Install the Oracle Storage 12 Gb/s SAS PCIe RAID HBA Card.
-
Return the server to operation.
-
Install the server top cover.
See Install the Server Top Cover.
-
Return the server to the normal rack position.
See Return the Server to the Normal Rack Position.
-
Reconnect the power cords to the power supplies, and power on the
server.
See Reconnect Power and Data Cables and Power On the Server. Verify that the power supply AC OK LED is
lit.
Note -
IMPORTANT: After replacing the
motherboard, you might need to manually program the product serial
number (PSN) into the new motherboard. This is necessary because the
motherboard is a secondary member of a select group (or quorum) of
components for maintaining the PSN for service entitlement, and if you
replace more than one of the quorum members during any given service
procedure, a secondary quorum member might need to be programmed with
the PSN.