When the toolbox daemon is started, it looks for the /etc/toolbox/conf/fabric.conf file. If the file is missing, the daemon starts the fabric configuration wizard. The wizard is also started with the set config wizard command. If the toolbox daemon is running and the fabric configuration wizard is invoked, the daemon tries to discover the following parameters. If the daemon is not running or is unsuccessful, you must provide the parameters to the fabric configuration wizard. These are the parameters:
Fabric name
Fabric M_Key
Fabric password
Number of racks
For each rack:
Rack name
Rack family
Rack type
Number of switches
For the first switch:
Host name
Management controller IP address
Password
Subnet Manager state
For all subsequent switches:
Host name
Password
Subnet Manager state