Install the Server
 | Caution - Do not attempt to move the server alone without a lift. For a one-person installation, all the main CRUs must be removed, and a lift must be used. For a two-person installation, all the CRUs must be removed, and a lift is optional. |
-
Prior to installing the server, confirm that you have removed the following
components.
-
Both processor modules
-
The main module
-
All four power supplies
-
All five fan modules
Refer to the SPARC T8-4 Server Service Manual for removal instructions.
-
- If you are using a mechanical lift, ensure that the lift is level and stable.
-
Lift the server up to the correct height.
Ensure that the bottom edge of the server has cleared the bottom of the shelf rails.
-
Slide the server into the rack.
- Secure the server to the front panel using four No. 2 Phillips screws.
-
Replace all of the components that you removed.
-
Both processor modules
-
The main module
-
All four power supplies
-
All five fan modules
Refer to the SPARC T8-4 Server Service Manual for installation instructions.
-