SPARC T8-4 Server Installation Guide

Determine Correct Rackmount Hardware

1. Ensure that the rack is stabilized.

   See Stabilize the Rack.

2. Determine the hardware needed for your rack installation.

   Rack Type Fastener Bags Required Square hole SCREW, SEMS, M6 X 16 CAGE NUTS, M6 Round hole (10-32) with corner bezel SCREW, SEMS, 10-32 X 10 SCREW, FLAT HEAD, M4 X 10 Round hole (M6) with corner bezel SCREW, SEMS, M6 X 12 SCREW, FLAT HEAD, M4 X 10 Round hole (10-32) inside installation SCREW, SHOULDER, 10-32 SCREW, FLAT HEAD, M4 X 10 Round hole (M6) inside installation SCREW, SEMS, M6 X 12 SCREW, FLAT HEAD, M4 X 10

   ---

   Note -  Some of the fastener bags that are included in the kit are not required to install this server.

   ---

3. Mark the rackmounting location.

   See Mark the Rackmounting Location.

Related Information

• Rack Compatibility

• Installing the Rackmount Kit

• Mark the Rackmounting Location

• Install the Shelf Rails