Go to main content

Oracle® X7 Series Servers Administration Guide

Exit Print View

Updated: October 2019

Reset BIOS Firmware to Default Settings (BIOS)

Setting defaults ensures that the server is operating with a configuration that is known to be good.

Note -  If the server is newly installed and this is the first time an operating system is being installed, then BIOS is probably already configured to its default settings.

Any changes you make in the BIOS Setup Utility using the F2 key are permanent until the next time you change them.

Before You Begin

Ensure that your server is equipped with a properly installed hard disk drive (HDD) or solid state drive (SSD).

For instructions, refer to your service manual.

  1. Access the BIOS Setup Utility.

    For instructions, see Accessing the BIOS Setup Utility.

  2. Press the F9 key to automatically load the optimal default settings.

    A message appears prompting you to continue this operation by selecting OK or to cancel this operation by selecting CANCEL.

  3. In the message, highlight OK, and then press Enter.
  4. To save your changes and exit the BIOS Setup Utility, press the F10 key.

    Alternatively, you can select Save and Exit from the Exit menu.