Unpack the Modular System
Allow ample space around the system to unpack it.
-
Unpack the system using the instructions attached to the side of the carton.
Tip -
Use a separate area from the installation area to remove the packaging material to reduce particle contamination before entering the final location of the modular system. Because of the size of the cardboard pieces, at least two people are required to remove the cardboard.
-
Move the modular system to its final location.
-
If it is a bottom-feed power system, perform the following steps to remove the power cables.
-
At the bottom of the system, remove enough nodes and/or filler panels to access the power cables (bundled inside and supported by a shipping tray).
See the Netra Modular System Service Manual Supplement.
-
Carefully pull out the power cables.
-
Remove the blue plastic shipping tray.
-
(Optional) Attach the modular system to a concrete floor.
See Secure the Modular System to a Concrete Floor.
- (Optional)
If you received nodes in separate boxes, go to Add Nodes Included in Shipment.