|Skip Navigation Links|
|Exit Print View|
|Sun Network QDR InfiniBand Gateway Switch HTML Document Collection for Firmware Version 2.0|
Reads QSFP cable information.
connector name present|portstate|info|dump [-h]
where name is the name of the connector (0A – 15A, 0A-ETH, 1A-ETH, 0B – 15B).
This hardware command performs a pass-fail test to verify that an InfiniBand cable is connected to a particular connector and to the switch chip port that the link routes. The command can also read the data registers of the cable and report FRU ID information.
The connector command is available from the /SYS/Switch_Diag, /SYS/Gateway_Mgmt, and /SYS/Fabric_Mgmt Linux shell targets of the Oracle ILOM CLI interface.
This table describes the options to the connector command and their purposes.
This example shows how to display the FRU ID information for connector 1A with the connector command.
# connector 1A info Cable connector 1A present Indentifier: QSFP Connector type: Copper pigtail Vendor: Amphenol Vendor OUI: 415048 Partnumber: 568400005 Revision: C Serialnumber: APF08510050019 Date: 081219 #