Attach the Data Cables

---

Caution - Data cables must never turn tighter than a 5-inch (127 mm) radius. A tighter radius damages the wires and fibers inside the cable.

---

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this procedure.

   See Installation Sequence.

2. Loosen the two captive thumbscrews that secure the cover to the cable management bracket.
   
3. Lift the cover off.
   
4. Remove the protective cap from the connector or transceiver and visually inspect the cable connector.

   The shell should not be bent and should be parallel to the inner boards. If the connector is bent or damaged, use a different cable.

5. Ensure that the retraction strap is folded back against the cable.
6. Orient the cable connector to the QSFP receptacle squarely and horizontally.

   Ensure that the L groove is up for the top row of receptacles, or that the L groove is down for the bottom row of receptacles.

   
   

   ---

   Note - On some QSFP cable connectors, there is a retraction strap. Both the retraction strap and L groove indicate the reference surface for the connector. When installing QSFP cables in the top row of receptacles (0A, 1A, 2A, and so on), ensure that the L groove and retraction strap are up. When installing QSFP cables in the bottom row of receptacles (0B, 1B, 2B, and so on) ensure that the L groove and retraction strap are down. Refer to Gateway Service, identifying the data cable.

   ---

7. Slowly move the connector in.

   As you slide the connector in, the shell should be in the center of the QSFP receptacle.

   
   

   • If the connector stops or binds after about 1/4 in. (5 mm) travel, back out and repeat from Step 6.

   • If the connector stops or binds with about 1/8 in. (2 mm) still to go, back out and repeat Step 7.

8. Continue to push the connector in until you feel a detent.
9. Place the cable into the open slot on the cable management bracket.
   
10. Repeat Step 4 through Step 9 for all cables to be installed, including the Ethernet cables at connectors 0A and 1A on the right side of the rear panel.
11. Replace the cover for the cable management bracket and tighten the thumbscrews.
    
12. Route the data cables so that they do not interfere with other cables, or with servicing the gateway or other systems.

    Use hook and loop fastener straps to bundle and secure the cables.

    ---

    Note - Do not use cable zip ties to bundle or secure the cables, because the ties damage the fibers inside the cables.

    ---

13. Check that the Link LEDs for cabled links are lit green.

    If the Link LED is unlit, the link is down. If the Link LED flashes, there are symbol errors. Refer to Gateway Service, checking the link status LEDs.

14. If possible, close the rack doors to maintain EMI compliance.
15. Check the link status.

    See Check Link Status.

Related Information

• Understanding Data Cabling

• Attach the Management Cables

• Attach the Power Cords

• Check Link Status