Oracle^® ILOM Protocol Management Reference for SNMP and IPMI Firmware Release 3.2.x

View Single Sensor Details

• To view details about a single sensor on a managed device, type:

  sensor get /target/sensor_name

  For example, to view sensor details about the system temperature (/SYS/T_AMB), you would type:

  $ ipmitool -I [orcltls|lanplus] -H SP_hostname_or_IPaddress -U username -P password
  sensor get /SYS/T_AMB

  ---

  Note -  The IPMI TLS interface (orcltls) is supported as of Oracle ILOM firmware version 3.2.8 and later. For a higher level of security, you should always specify the IPMI TLS interface (-I orcltls) when executing Oracle ILOM commands from the IMPItool utility. For more information about using the IPMI TLS interface from Oracle, see these topics:IPMI TLS Service and Interface and Configure IPMI Management Access for Increased Security in Oracle ILOM Security Guide Firmware Releases 3.0, 3.1, and 3.2

  ---

  The output might look like the following:

  Locating sensor record...
  Sensor ID              : /SYS/T_AMB (0x8)
   Entity ID             : 41.0
   Sensor Type (Analog)  : Temperature
   Sensor Reading        : 24 (+/- 0) degrees C
   Status                : ok
   Lower Non-Recoverable : 0.000
   Lower Critical        : 4.000
   Lower Non-Critical    : 10.000
   Upper Non-Critical    : 35.000
   Upper Critical        : 40.000
   Upper Non-Recoverable : 45.000
   Assertions Enabled    : lnc- lcr- lnr- unc+ ucr+ unr+
   Deassertions Enabled  : lnc- lcr- lnr- unc+ ucr+ unr+