Install the Internal HBA Card in PCIe Slot 4
This is a cold-service procedure that must be performed by qualified service
personnel. Power down the server completely before performing this procedure.
-
Unpack the replacement HBA card and the SAS cables, and retrieve the PCIe
riser for slot 3.
-
Using a T10 Torx screwdriver, remove the standard HBA bracket that shipped
with the replacement HBA card.
-
Install the special fitted bracket that was removed in Remove the Internal HBA Card From PCIe Slot 4.
-
If you are installing new SAS cables, see Install the HBA SAS Cable Assembly.
-
Connect the SAS cables to the internal HBA card.
-
Insert the rear bracket on the internal HBA card into the rear connector
on the PCIe riser.
-
Insert the internal HBA card connector into the bottom connector on the
riser for PCIe slot 3 and 4.
-
Install the PCIe riser.
See Install the PCIe Riser Into PCIe Slots 3 and 4.
-
Install fan module FM 0.
See Install a Fan Module.
-
Return the server to operation.
See Returning the Server to Operation.