SPARC S7-2 Server Service Manual

Remove the Server From the Rack

---

Caution  -  The server weighs approximately 18.1 kg (40.0 lbs). Two people are required to dismount and carry the chassis.

---

1. Disconnect all the cables and power cords from the server.
2. Remove the CMA.

   See Remove the Cable Management Arm.

3. Extend the server to the maintenance position.

   For instructions, see Extend the Server to the Service Position.

4. From the front of the server, pull the green slide rail release tabs toward the front of the server, and pull the server out of the rack until it is free of the rack rails.

   A slide rail release tab is located on each slide rail (see Extend the Server to the Service Position (2).

   ---

   Note -  To pull the green slide rail release tab, place your finger in the center of the tab, not on the end, and apply pressure as you pull the tab toward the front of the server.

   ---

5. Set the server on a sturdy work surface.

Related Information

• Disconnect Cables From the Server

• Prevent ESD Damage