This section provides an overview of the Oracle ZFS Storage 7320 controller. For installation instructions, refer to Installing a 7x20 Controller. For service instructions, refer to Servicing the 7420 or 7320 Controller in Oracle ZFS Storage Appliance Customer Service Manual.
Two C13 connectors, which work on 110-220v outlets
Nominal frequencies: 50/60Hz
Nominal voltage range: 100-120/200-240 VAC
Maximum current AC RMS: 9.0 amps Max
AC operating range: 90-264 VAC
3.3 VDC STBY: 3.6A
+12 VDC: 62.3A
Max power consumption: 873 W
Max heat output: 2977 BTU/hr
Volt-Ampere rating: 891 VA @ 240 VAC, 0.98P.F.
The 7320 controller base configuration options are:
Single or cluster
24GB or 96GB RAM
2x2.4GHz Quad-Core processors
One external SAS HBA
Four 10/100/1000 Ethernet ports
The following figure and legend identify the front panel LEDs.
Figure 39 7320 Controller Front Panel
The following figure and legend identify the 7320 front panel drive locations. Two mirrored hard disk drives (HDDs) that store the operating system reside in slots 0 and 1. Up to four solid state drives (ReadZilla SSDs), which store the read cache, fill slots 2 through 5, in order. Slots 6 and 7 are empty and must contain drive fillers.
Figure 40 7320 Front Panel Drive Locations
For information about PCIe cards, see 7320 Configuration Options in Oracle ZFS Storage Appliance Customer Service Manual.
Figure 41 7320 Controller Rear Panel
The 7320 controller has the following ports:
Ethernet Ports - There are four RJ-45 Gigabit Ethernet ports (NET 0, NET 1, NET 2, NET 3) located on the motherboard that operate at 10/100/1000 Mbit/sec. These network interfaces must be configured before use.
Network Management Port - The network management connector (NET MGT) is an RJ-45 10/100 BASE-T Ethernet port and provides an alternate terminal interface to the SP console.
Serial Management Port - The serial management connector (SERIAL MGT) is an RJ-45 connector and is a terminal connection to the SP console.