Go to main content

man pages section 7: Device and Network Interfaces

Exit Print View

Updated: July 2017
 
 

sockio(7I)

Name

sockio - ioctls that operate directly on sockets

Synopsis

#include <sys/sockio.h>

Description

The ioctls listed in this manual page apply directly to sockets, independent of any underlying protocol. The setsockopt() call (see getsockopt(3SOCKET)) is the primary method for operating on sockets, rather than on the underlying protocol or network interface. ioctls for a specific network interface or protocol are documented in the manual page for that interface or protocol.

SIOCSPGRP

The argument is a pointer to an int. Set the process-group ID that will subsequently receive SIGIO or SIGURG signals for the socket referred to by the descriptor passed to ioctl to the value of that int. The argument must be either positive (in which case it must be a process ID) or negative (in which case it must be a process group).

SIOCGPGRP

The argument is a pointer to an int. Set the value of that int to the process-group ID that is receiving SIGIO or SIGURG signals for the socket referred to by the descriptor passed to ioctl.

SIOCCATMARK

The argument is a pointer to an int. Set the value of that int to 1 if the read pointer for the socket referred to by the descriptor passed to ioctl points to a mark in the data stream for an out-of-band message. Set the value of that int to 0 if the read pointer for the socket referred to by the descriptor passed to ioctl does not point to a mark in the data stream for an out-of-band message.

See Also

ioctl(2), getsockopt(3SOCKET)