Go to main content

Oracle® Server X8-2 Service Manual

Exit Print View

Updated: January 2021

Remove the Temperature Sensor

  1. Prepare the server for service.
    1. Power off the server and disconnect the power cords from the power supplies.

      See Powering Down the Server.

    2. Extend the server to the maintenance position.

      See Extend the Server to the Maintenance Position.

    3. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.

      See Take Antistatic Measures.

    4. Remove the server top cover.

      See Remove the Server Top Cover.

  2. Disconnect the temperature sensor cable from the disk backplane.
    image:Figure showing the temperature sensor cable being disconnected from                             the disk backplane.
  3. Using a Phillips screwdriver, remove the two screws that secure the front indicator module (FIM) assembly to the server chassis [1].
    image:Figure showing the temperature sensor being removed from the                             chassis.
  4. Carefully slide the FIM assembly toward the front of the server to remove it from the chassis [2].
  5. Remove the temperature sensor from the plastic housing by pulling the sensor from its seated location. Then remove the sensor cable by pulling it through the slit in the housing [2, 3].
  6. Remove the temperature sensor and cable by carefully pulling the sensor cable rearward and through the left-front chassis sidewall. Then lift the temperature sensor from the chassis [4].

Related Information