Install a Cable Management Hook
You can route the equipment's data cables using
the cable management hooks and spring nuts found in the shipping
kit.
- Retrieve
a cable management hook, M5 screws, and a spring nut from the shipping
kit.
- Insert a spring nut at a 45-degree
angle into the desired rack frame groove.
Once in the groove, position the spring nut so that the threaded
nut is showing through the rack frame.
- Move the spring nut up or down
the rack frame groove to where you are installing the cable management
hook.
- Place the cable management hook
over the spring nut, and using a No. 2 screwdriver, tighten an M5
screw to secure the hook into the spring nut.
- Route data cables from the installed
equipment through the installed cable management hooks out of the
rack.
Note - Refer to the equipment documentation for additional
cable routing instructions or guidelines.