Install the FMM

Language:

Caution - Two persons are required to install the FMM, to prevent damage to the equipment and personnel.

Caution - Make sure that the Ethernet cables are on top of the FMM when installing the FMM.

At the front of the modular system, insert the replacement FMM to about six inches less than full installation.

From the rear of the modular system:
1. Lift all cables that will connect to the FMM up onto the FBH tray.
2. Pull the FMM into the frame the rest of the distance, to completely install it.

From the front of the modular system:

Attach all the blue cables, then the orange Ethernet cables.

Note - Cables are labeled U19, PT-xx - where xx is the port number.

Caution - Reconnecting the Ethernet cables incorrectly will cause connectivity issues and unpredictable system behavior.

Using a No. 1 Phillips screwdriver, install the filler panel support brackets at slot 19.

Using a No. 3 Phillips screwdriver, reinstall the node support bracket and filler panel support brackets at slot 20 with the saved screws.
Make sure that the orientation is correct, with the shelf on top.

From the rear of the modular system:
1. Attach the DB-9 LED panel cable to the DB-9 port.
2. Attach the Cat-5e cable to the console port.
3. Attach the FBH cables to the correct ports as follows:
  1. Review the labels on the two FBH cable pairs.
    One pair of cables routes to the upper section (above the FMM) of the rack and will connect to the top ports on the FMM. The other pair of cables routes to the lower section of the rack (below the FMM) and will connect to the bottom two ports on the FMM.
  2. From the lower cable pair, locate the cable labeled "U19, PT-FBH 2/3," and connect it to port 2.
  3. Locate the remaining lower cable labeled "U19, PT-FBH 1/4," and connect it to port 4.
  4. From the top cable pair, locate the cable labeled "U19, PT-FBH 1/4," and connect it to port 1.
  5. Locate the remaining top cable labeled "U19, PT-FBH 2/3," and connect it to port 3.
4. Attach ties to secure the FBH cables to the tray.
5. Attach the power cables on each side.
6. Using a No. 3 Phillips screwdriver, reinstall the support bracket at slot 20 with the saved screws.
  Note - After power on, FMM automatically detects and programs the frame configuration based on the backup copies stored in the two system management software PCB and the FMM switch.
7. If it is an ASR asset, activate the FMM.
  See Activate an ASR Asset.
8. If you want to view the FMM SN, from the FMM CLI, type: show /SYS component_serial_number.