Replace an Ethernet Cable From FBS to a Switch or a Coupler Panel
This procedure describes how to replace cables from the FBS to the coupler panel, switch serial management ports, or switch Ethernet ports.
-
Follow safety and ESD precautions.
See Safety and ESD Precautions.
-
Remove FBS cover at the location of the failed cable.
See Replace an FBS PCB for FBS cover removal instructions.
-
Disconnect the faulty cable.
-
Connect the replacement cable.
-
Remove the nearby FBS covers, and start laying in the replacement cable,
reinstalling FBS covers as you install the cable up the frame.
See Precautions for Handling Cords and Cables.
-
When you have the replacement cable up to the FBS at slot 34, install the
remaining FBS covers.
-
Disconnect the faulty cable from the switch or the coupler panel.
Note -
The coupler panel connection is on the side of the coupler panel that faces the front of the modular system. See
Rear Components.
-
Connect the replacement cable to the switch or coupler panel.
-
Coil up any excess cable.