Replace the DB-9 LED Cable
You can replace the DB-9 LED cable with no impact to the operation of the modular system.
Obtain a No. 3 Phillips screwdriver for the procedure.
-
Follow safety and ESD precautions.
See Safety and ESD Precautions.
-
From the front of the modular system:
-
Remove the status LED panel located on the top front of the
modular system.
See Remove the LED Panel.
-
Disconnect the existing cable from the LED panel.
-
Connect the new cable to the LED panel, then route the cable to the rear of the modular system and over the coupler panel at slot 41.
-
Install the LED panel.
See Install the LED Panel.
-
At the rear of the modular system:
-
Remove the node rear support bracket from slot 20.
-
Starting from the top, remove the FBS covers a few at a time.
See Replace an FBS PCB for FBS cover removal instructions.
See Precautions for Handling Cords and Cables.
-
Lay the new cable in the right-side channel.
-
If possible, remove the faulty cable completely.
-
Disconnect the DB-9 cable from the FMM.
-
Connect the new DB-9 cable to the FMM.
-
Install the node rear support bracket at slot 20.