Use the Auto Mode Sequencer (TTY UI)

Use the Mode Sequencer to determine the sequence of tests that will be run in Auto mode. By default, the Sequencer is switched off (set to Disable).

1. In the TTY main window, use the arrow keys to mode_sequencer, and then press return.

   The Mode Sequencer screen is displayed.

2. In the Sequencer field, use the arrow keys select Enable, and then press Return.
3. Use the arrow keys to select the modes, and then press Return.

   • First: Select one of the three test modes that will run first. By default, this option is set to None.

   • Second: Select one of the three test modes that will run second. By default, this option is set to None.

   • Third: Select one of the three test modes that will run third. By default, this option is set to None.

4. In the Loop field, specify the number of times the sequence will run, and then press Return.

   The value must be between 1 and 99999. By default, this is set to 1.

5. Use the arrow keys to select Apply, and then press Return.

Related Information

• Auto Mode Sequencer

• TTY UI Overview

• Display TTY UI HELP and Release Table

• View the Host System Configuration (TTY UI)

• Configuring the Test Session (TTY UI)

• Begin the Test Session (TTY UI)

• Monitor the Test Session

• Stop the Test Session (TTY UI)

• Review the Log Files (TTY UI)

• Reset the Test Session Results (TTY UI)

• Saving a Test Configuration for Repeated Use

• Reprobe the Devices (TTY UI)

• Quit VTS TTY UI