VTS Messages
There are various messages for each of the tests that run
under VTS. Most messages contain all the explanatory text that is
possible for each event that is encountered. Some messages are information
messages (INFO, VERBOSE, WARNING) which do not represent an error,
while some messages are error messages (ERROR and FATAL), indicating
that the test detected a failure or was unable to run.
Whenever possible, the error message supplies a message type,
followed by the message text, one or more probable causes, and one
or more recommended corrective actions. The following table describes
the types of messages you might encounter. All messages are displayed
in the Message panel, and most are logged in one of the logs (Info
or Error).
Table 2 VTS Messages
|
|
|
INFO |
Info log |
Displayed when a non-error test event
occurs. |
ERROR |
Error and Info logs |
Displayed when a test detects an error,
often an indication of a problem with a specific function or feature
of the device under test. |
FATAL |
Error and Info logs |
Displayed when a test encounters a severe
condition that might cause the test to exit, such as a failure to open
a device. These messages generally do not indicate a hardware failure. |
VERBOSE |
Verbose log |
Test progression messages that are displayed
when the verbose feature is enabled. |
WARNING |
Info log |
These messages warn you of a condition
that might prevent the physical test to run with the test's full capabilities.
These warning messages do not necessarily indicate an error. |
ALERT |
|
Displayed when a test encounters a software
error or a resource issue that causes the test to exit. |
|