|
|
Disk_Data_Write |
This parameter enables Write tests on
disk media for Disk test.For example:
Disk_Data_Write All=Enable |
Disk_IOsize |
This parameter enables to set Disk I/O
size in Disk test. The I/O size is in kilobytes.
For example:
Disk_IOsize All=<n> |
Disk_Ignore_Target |
Parameter to ignore certain targets for
Disk test. The targets need to be mentioned in separate entries
as shown below.
For example:
Disk_Ignore_Target c0=Ignore
Disk_Ignore_Target c0t0=Ignore
Disk_Ignore_Target c0t0d0=Ignore
Disk_Ignore_Target c0t0d0s2=Ignore |
NFS_Disk_Testing |
To enable File system testing on NFS
disks.
For example:
NFS_Disk_Testing All=EnableNFS_Disk_Testing <NFS mount path1>=EnableNFS_Disk_Testing <NFS mount path2>=Enable |
Disk_File_Size |
This parameter enables to set file size
for file system testing.
For example:
Disk_File_Size All=2000K |
Disk_File_IOSize |
This parameter enables to set I/O size
for file system testing,
For example:
Disk_File_IOSize All=64k |
Disk_Error_Statistics |
This paramater enables the users to monitor
the error statistics. For example,
Disk_Error_Statistics=Enable |
Read_Intensive_SSD_Ratio |
This parameter specifies the read write
ratio for read intensive SSDs, for example, TOSHIBA THNSNC512GBSJ.
For example,
Read_Intensive_SSD_Ratio All=xx:yy
where xx is the ratio of the number
of reads and yy is the ratio of number
of writes.
These options allow the users to qualify the read intensive
SSDs and increase the stress on these SSDs by configuring the number
of reads and writes through the sunvts.conf file. |
Write_Intensive_SSD_Ratio
|
This parameter specifies the read write
ratio for write intensive SSDs, for example, STEC ZeusIOPS G3.
For example,
Write_Intensive_SSD_Ratio All=xx:yy
where xx is the ratio of the number
of reads and yy is the ratio of number
of writes.
These options allow the users to qualify the write intensive SSDs
and increase the stress on these SSDs by configuring the number
of reads and writes through the sunvts.conf file. |
VTS_CUSTOM_PLATFORMNAME |
This parameter enables to use the Axiom
Disk LT Profile. For example,
VTS_CUSTOM_PLATFORMNAME Oracle_Flash_Storage |
Disk_Type_Ignore_Target
|
This parameter disables disk testing on selective devices based on
the device type.
Below are the options to disable testing based on the disk
type:
-
Disk_Type_Ignore_Target
HDD=Ignore
-
Disk_Type_Ignore_Target
SSD=Ignore
-
Disk_Type_Ignore_Target
EUSB=Ignore
-
Disk_Type_Ignore_Target
NVME=Ignore
-
Disk_Type_Ignore_Target
RM=Ignore
|